Fix i2c docs formatting (#3425)
This commit is contained in:
parent
016e8caa09
commit
3ed76a2be4
|
@ -9,14 +9,15 @@ ESP8266 chip does not have hardware I²C, so module uses software I²C driver.
|
|||
It can be set up on any GPIO pins including GPIO16 (see below).
|
||||
|
||||
This module supports:
|
||||
- Master mode
|
||||
- Multiple buses (up to 10) with different speeds on each bus
|
||||
- Standard(Slow, 100kHz), Fast(400kHz) and FastPlus(1MHz) modes or an arbitrary clock speed
|
||||
- Clock stretching (slow slave device can tell the master to wait)
|
||||
- Sharing SDA line over multiple I²C buses to save available pins
|
||||
- GPIO16 pin can be used as SCL pin, but selected bus will be limited to not more than FAST speed.
|
||||
|
||||
HIGH-speed mode (3.5MHz clock) and 10-bit addressing scheme is not supported.
|
||||
- Master mode
|
||||
- Multiple buses (up to 10) with different speeds on each bus
|
||||
- Standard(Slow, 100kHz), Fast(400kHz) and FastPlus(1MHz) modes or an arbitrary clock speed
|
||||
- Clock stretching (slow slave device can tell the master to wait)
|
||||
- Sharing SDA line over multiple I²C buses to save available pins
|
||||
- GPIO16 pin can be used as SCL pin, but selected bus will be limited to not more than FAST speed.
|
||||
|
||||
HIGH-speed mode (3.5MHz clock) and 10-bit addressing scheme is not supported.
|
||||
|
||||
You have to call `i2c.setup` on a given I²C bus at least once before communicating to any device connected to that bus, otherwise you will get an error.
|
||||
|
||||
|
|
Loading…
Reference in New Issue