Update README.md

lua_modules/hdc1000/README.md

@@ -1,24 +1,24 @@
-HDC1000 NodeMCU Library
+HDC1000 NodeMCU module
 =======================
 
-Here's my NodeMCU library for the TI HDC1000 temperature and humidity sensor. It should work with the HDC1008 too but I haven't tested it.
+Here's my NodeMCU module for the TI HDC1000 temperature and humidity sensor. It should work with the HDC1008 too but I haven't tested it.
 
 ### Setup your sensor:
 First, require it:
 
-`hdc1000 = require("hdc1000")`
+`HDC1000 = require("HDC1000")`
 
 Then, initialize it:
 
-`hdc1000.init(sda, scl)`
+`HDC1000.init(sda, scl)`
 
 Configure it:
 
-`hdc1000.config()`
+`HDC1000.config()`
 
 Default options set the address to 0x40 and enable both temperature and humidity readings at 14-bit resolution, with the integrated heater on. You can change them by initializing your sensor like this:
 
-`mySensor.begin(address, resolution, heater);`
+`HDC1000.config(address, resolution, heater);`
 
 "resolution" can be set to 14 bits for both temperature and humidity (0x00 - default) 11 bits for temperature (0x40), 11 bits for humidity (0x01), 8 bits for humidity (0x20)
 "heater" can be set to ON (0x20 - default) or OFF (0x00)
@@ -26,14 +26,14 @@ Default options set the address to 0x40 and enable both temperature and humidity
 ### Read some values
 You can read temperature and humidity by using the following commands:
 
-`temperature = hdc1000.getTemp()` in Celsius degrees.
+`temperature = HDC1000.getTemp()` in Celsius degrees.
 
-`humidity = hdc1000.getHumi()` in %
+`humidity = HDC1000.getHumi()` in %
 
 ### Check your battery
 
 The following code returns true if the battery voltage is <2.8V, false otherwise.
 
-`isDead = hdc1000.batteryDead();`
+`isDead = HDC1000.batteryDead();`
 
 Happy making! Also, check out my Breakout Board and Arduino library for this chip: http://b.truzzi.me/hdc1000-temperature-and-humidity-sensor-breakout-with-arduino-library/.