* I2C driver speed-up, i2c.SLOW, i2c.FAST and user-defined speed selection
* - Multiple buses (up to 10) with different speeds on each bus
- Standard(Slow, 100kHz), Fast(400kHz) and FastPlus(1MHz) modes or an
arbitrary clock speed
- Sharing SDA line over multiple I²C buses to save available pins
- GPIO16 pin can be used as SCL pin, but it does not support clock
stretching and selected bus will be limited to FAST speed.
* Dynamic memory allocation, error checks, simplification, timing tweaks.
* Separated the code of old driver for better compatibility and simplicity
* Change of driver interface
* Add bus status check in setup(); simplify getDC(); remove unnesessary lines in ACK read/write
* Fix for moved doc file and trailing whitespaces
AFAIK no one uses the wifi.startsmart() and wifi.stopsmart(). Removing
them frees up an extra 20-25K of Flash to use as filesystem. So I have
added a new config define WIFI_SMART_ENABLE which is enabled by default
so the default functionality is the same, but if this is commented out
then this code is omitted.
I have also removed wofs and upgrade from this build as we no longer
support these.
There was only one genuine use of this macro, all other places were
using it only as a necessary compensation. While this was fine as long as
it was the first meg of flash which was mapped, it became incorrect and
quite dangerous whenever this assumption did not hold (such as when
running from the second slot in an OTA scenario).
The flash API now uses actual addresses, not translated/mapped
addresses, and the users of this API have been adjusted accordingly.
This makes the flash API work correctly regardless of what flash mapping
is in use.
The old macro is still available under the new name
INTERNAL_FLASH_MAPPED_ADDRESS, and this is used to detect flash writes
where the source is mapped flash (and thus has to be bounced), and to
adjust the _flash_used_end linker symbol when used with
flassh_find_sector() by the filesystem code. The latter usage is not
OTA-proof, but in an OTA scenario the filesystem needs a fixed location
anyway and thus would not use this code path.
Johny Mattsson
Natalia
Arnim Läuger
dnc40085
TerryE
Johny Mattsson
Johny Mattsson
HuangRui
iabdalkader
funshine