3.7 KiB

Raw Blame History

rfswitch Module

Since	Origin / Contributor	Maintainer	Source
2016-12-01	Roman Fedorov	Roman Fedorov	rfswitch.c

Module to operate 433/315Mhz devices like power outlet sockets, relays, etc. This will most likely work with all popular low cost power outlet sockets with a SC5262 / SC5272, HX2262 / HX2272, PT2262 / PT2272, EV1527, RT1527, FP1527 or HS1527 chipset.

This module uses some code from the original rc-switch Arduino lib but NodeMCU and Arduino are not fully compatible. This required that rc-switch was rewritten into rfswitch NodeMCU with Lua support.

Connection of transmitter

Transmitter	ESP8266	comments
vin or +	3V3	3.3 - 5 volts on ESP8266 or other power source
ground or -	GND	ground should be connected to ESP8266 and to power source
data pin	6	almost any pin on ESP8266

You can read more about connection here.

Selecting proper protocol

This module supports transmitting data using 6 different protocols and you should use one most suitable for your needs. Receiving data is not supported yet. So, you cannot listen radio air and get protocol details using Lua.

The easiest way to get the correct protocol is to connect the radio receiver to your ESP8266 or Arduino, then run ReceiveDemo_Advanced.ino and view output in serial console (example1, example2).

You should get something like this:

Decimal: 11001351 (24Bit)
Binary: 101001111101111000000111
Tri-State: not applicable
PulseLength: 517 microseconds
Protocol: 5

Raw data: 7200,1004,528,504,1048,980,336,1176,356,1176,352,1180,1108,412,356,1172,364,1168,356,1160,1176,1124,412,336,1180,1116,440,328,1188,340,1228,1060,416,1160,380,1160,1108,464,1068,436,328,1232,1060,412,1116,440,1088,428,3024,

More detailed about low level protocol specifications could be found here You can visualize a telegram copy the raw data by paste it into http://test.sui.li/oszi/

rfswitch.send()

Transmit data using the radio module.

Syntax

rfswitch.send(protocol_id, pulse_length, repeat, pin, value, length)

Parameters

protocol_id positive integer value, from 1-6
pulse_length length of one pulse in microseconds, usually from 100 to 650
repeat repeat value, usually from 1 to 5. This is a synchronous task. Setting the repeat count to a large value will cause problems. The recommended limit is about 1-4. If you need more, then call it asynchronously a few more times (e.g. using node.task.post)
pin I/O index of pin, example 6 is for GPIO12, see details
value positive integer value, this is the primary data which will be sent
length bit length of value, if value length is 3 bytes, then length is 24

Returns

nil

Example

-- Lua transmit radio code using protocol #1
-- pulse_length 300 microseconds
-- repeat 5 times
-- use pin #7 (GPIO13)
-- value to send is 560777
-- value length is 24 bits (3 bytes)
rfswitch.send(1, 300, 5, 7, 560777, 24)

3.7 KiB Raw Blame History